How to create an evacuation routes overlay: Difference between revisions

From Tygron Support wiki
Jump to navigation Jump to search
No edit summary
re-added the required tab indication
 
(One intermediate revision by one other user not shown)
Line 7: Line 7:
| Add an [[Area]], and draw it anywhere in the [[project map]] and with an [[Attribute]] named DESTINATION_AREA set to 1. This location will be the evacuation point.
| Add an [[Area]], and draw it anywhere in the [[project map]] and with an [[Attribute]] named DESTINATION_AREA set to 1. This location will be the evacuation point.
| Add a [[Travel Distance Overlay]].
| Add a [[Travel Distance Overlay]].
| Under "Keys", opt to use a "blocking input", and select the [[Combo Overlay]] created earlier. This will disqualify certain routes from being traversed.
| Under "Keys", set the [[Blocking prequel (Travel Distance Overlay)|Blocking prequel]] of the Travel Distance Overlay to the [[Combo Overlay]] created earlier. This will disqualify certain routes from being traversed.
| Recalculate, and play the [[Travel Distance Overlay]]
| Recalculate, and play the [[Travel Distance Overlay]]
|  As the simulation progresses, green evacuation routes will turn red to indicate excessive water stress.
|  As the simulation progresses, green evacuation routes will turn red to indicate excessive water stress.

Latest revision as of 08:36, 11 November 2026

Combine Water Overlay height results with the Travel Distance Overlay to model valid evacuation routes during floods.

How to create an Overlay for calculated evacuation routes:
  1. Add a Water Overlay.
  2. Set the amount of rainfall of the Water Overlay to a total of 60mm in 60 minutes, followed by 0 minutes of dry period.
  3. Add a Combo Overlay, with the Water Overlay set to input A, and a formula of GT(AT, 0.2). This computes all places where a route would be blocked (1) or not (0), by having more than 20cm of water stress, for each timeframe.
  4. Add an Area, and draw it anywhere in the project map and with an Attribute named DESTINATION_AREA set to 1. This location will be the evacuation point.
  5. Add a Travel Distance Overlay.
  6. Under "Keys", set the Blocking prequel of the Travel Distance Overlay to the Combo Overlay created earlier. This will disqualify certain routes from being traversed.
  7. Recalculate, and play the Travel Distance Overlay
  8. As the simulation progresses, green evacuation routes will turn red to indicate excessive water stress.

Notes

  • Expand this setup with another Combo Overlay to highlight locations that lose their valid evacuation routes over time.

See also