How to check for errors when using the network wizard: Difference between revisions
Jump to navigation
Jump to search
(Created page with "When creating or importing network data using the net wizard, but also when stepping through the available steps of the wizard without effecting any changes, there are 2 validation steps where all preceding information is checked. These validation steps will check the following for all active network types: * There is a root node * All net lines are connected directly or indirectly to the root node * All net loads are connected via paths c...") |
No edit summary |
||
| Line 8: | Line 8: | ||
* All net loads are part of a cluster | * All net loads are part of a cluster | ||
[[Category:Network]][[Category:How-to]] | [[Category:Network]][[Category:How-to's]] | ||
Revision as of 14:09, 7 October 2022
When creating or importing network data using the net wizard, but also when stepping through the available steps of the wizard without effecting any changes, there are 2 validation steps where all preceding information is checked. These validation steps will check the following for all active network types:
- There is a root node
- All net lines are connected directly or indirectly to the root node
- All net loads are connected via paths composed of net lines to the root note
- All net nodes with only 1 net line connected to them have a net load connected to them
- All net nodes with a net load connected to them only have 1 net line connected to them
- All net loads are part of a cluster