How to add and configure hydraulic structures (Water Overlay)

From Tygron Support wiki
Jump to navigation Jump to search
Please note: This page is currently being updated.


Manually add and remove hydraulic structures

Editor → Current Situation (Ribbon tab) → Buildings (Ribbon bar)
How to add a hydraulic structure (example: inlet):
  1. From the Buildings dropdown select "Add Building".
  2. Name your new building.
  3. Click Change Function.
  4. Select (1) the correct category > (2) the desired function > (3) Apply.
  5. Click Draw Area.
  6. Select (1) one or more grid cells on the map for the desired location of the new building > (2) Apply Selection.
  7. In the Configuration Wizard of the Flooding Overlay at (1) the corresponding step > select (2) the new building > (3) Next.
  8. Finally, test the new hydraulic structure by running the simulation.

  • 1. Select Add Building.

  • 2. Name your new building.

  • 3. Click Change Function.

  • 4. Select (1) the correct category > (2) the desired function > (3) Apply.

  • 5. Click Draw Area.

  • 6. Select (1) one or more grid cells on the map for the desired location of the new building > (2) Apply Selection.

  • 7. In the Configuration Wizard of the Flooding Overlay at (1) the corresponding step > select (2) the new building > (3) Next.

  • 8. Finally, test the new hydraulic structure by running the simulation.

How to remove a hydraulic structure (example: inlet):
  1. From the Buildings dropdown select "Show Buildings".
  2. Select (1) the building you whish to remove > (2) Remove > (3) Yes.

  • 1. Select Show Building.

  • 2. Select (1) the building you wish to remove > (2) Remove > (3) Yes.

Import and export hydraulic structures

Editor → Current Situation (Ribbon tab) → Buildings (Ribbon bar)
How to import a hydraulic structure:
  1. From the Buildings dropdown select "Import Geo Data".
  2. Click Next and select your import method.
  3. Proceed by following the steps as stated on the Geo Data Wizard page.

  • 1. Select Import Geo Data.

  • 2. Select (1) your import method > (2) Next and continue with the subsequent steps.

How to export a hydraulic structure:
  1. From the Buildings dropdown select "Export GeoJSON File".
  2. (1) Filter on the building type you wish to export > (2) click Export.
  3. Proceed by going through the subsequent steps.

  • 1. Select Export GeoJSON File.

  • 2. (1) Filter on the building type you wish to export > (2) click Export.

Retrieved from "https://support.tygron.com/w/index.php?title=How_to_add_and_configure_hydraulic_structures_(Water_Overlay)&oldid=26140"