Water Module getting started

Getting started with the water module in the Tygron Platform can seem to be a difficult process. By following a few basic steps and completing the wizard belonging to the selected water overlay(s), completing this process will be much easier.

To use the water module and its calculations in the three dimensional world of the Tygron Platform, a couple of overlays are available. These overlays use the water module to calculate and simulate the water model in the project area. Results will be visualized as a two dimensional layer imposed over the 3D world.

Preparing the project

To be able to use the water module, a valid project needs to be loaded in the editor of the Tygron Platform. # Start the Tygron Platform client.

1. Create or load a project at the required location.

Selecting the overlay

	Rainfall Overlay	provides insight into the water stress and impact caused by (excessive) rainfall
	Flooding Overlay	provides insight into water stress and impact caused by breaches in levees or other sources causing excessive water inflow
	Groundwater Overlay	provides insight into long-term processes of water flow both on the surface and underground

Configuring the overlay

Water Overlay Wizards
	Rainfall Overlay Wizard		Flooding Overlay Wizard		Groundwater Overlay Wizard

How-to's

• Add and remove an overlay
• Edit an overlay legend

• Introduction
• Overview
• Getting started
• Configuration
• Use cases
• Theory
• Benchmarks
• Tips and tricks